When you are in a panic for a last minute gift and you have a laser cutter, the sky is the limit! It is a lot more fun to make a gift than to just buy one, so yesterday we had some fun doing some customization to a Rainbow Light Show kit.
Rob designed some constellations in Inkscape and he was looking for a way to integrate them with the Rainbow Light Show. Building on our MakerCase box building expertise from a previous blog post, we thought it would be fun to edge-light a piece of clear acrylic with the LED Strip from the Rainbow Light Show.
The results could not have been better, check it out:
Comments will be approved before showing up.