Protect all your GPIO pins with this board. It sits comfortably in-between your Raspberry Pi 2, A+ or B+ and your project to provide protection from accidental shorts or voltage slips.
Each GPIO is protected by a 330ohm resistor to limit excessive current, and a zener diode to sink any voltage up to 5v meaning it is safe enough to use 5v logic sensors quickly and easily with your Raspberry Pi.
The design is shaped to fit inside the Cyntech Pi 2 / Model B+ case and allow a GPIO ribbon cable to extend outside of the case to connect to a breadboard and split or other expansion board.
Perfect for teaching environments to help prolong the life of your Raspberry Pi.
Features a cutout for the camera module
Includes a ribbon cable!
This comes unsoldered, so some soldering skill is required to attach the headers.
The easiest way to prototype using your Raspberry Pi. The paddle board features individually sprung...
The easiest way to prototype using your Raspberry Pi. The Raspberry Split Mini fits perfectly...
The easiest way to prototype using your Raspberry Pi. The Raspberry Split fits perfectly on...
Protect your SD card thanks to this clip in cover, that fits flush with the...